Re: Simulating a multi subnet environment

HI,

Thanks, I'm clear with setting up 3 Vlans and Port group for a vSwitch0. Also i can add the Router Appliance.

But not clear below steps?

For each monowall, there is a Lan and Wan interface. ( 2 NICs or 3 Nics?)

In your case you can use the the IP ranges 10.0.1.x,10.0.2.x & 10.0.3.x for this. ? Not clear

The Wan ip range will correspond to your 3 vlans in real world, ie the network in which your ESXi servers are connected.

Since there is only one NIC card in the servers, you will hve to enable trunk port on it to allow the 3 Vlans? How?

Do we need 3 vSwitchs?

AS